Mazdaspeed Forums

Mazdaspeed Forums (http://www.mazdaspeedforums.org/forum/)
-   Gen2 MS3 General Discussion (http://www.mazdaspeedforums.org/forum/f544/)
-   -   Post your 1/4 trap speed (http://www.mazdaspeedforums.org/forum/f544/post-your-1-4-trap-speed-119978/)

heli4me 07-26-2012 10:45 AM

Post your 1/4 trap speed
 
Just looking to see what others are trapping in the 1/4. With similar
Mods as myselve...
I'm trying to figure out if I might have a issue with the car
Or driver....LOL
I have Sri - test pipe- water/meth injection- all 3 mounts
Tuned by a well respected tuner here on the forums with 50/50 e-85.
Anyway I have been reading it's nothing for our cars to
Trap 106/107 in the 1320 however mine can only hit 101
With the above mods ...
So just trying to get a comparison on this as to the possibility
That I might have a issue with my car ( other than the driver)
Thanks in advance ......

EdgeAutosport.com 07-26-2012 10:50 AM

Where are you located and sounds like driver mod is needed for sure :tapedshut:

tooslow10 07-26-2012 10:50 AM

my best 1/4 e.t was 116....well...with other mods on top of urs..

heli4me 07-26-2012 11:04 AM

Quote:

Originally Posted by eric@edgeautosport (Post 1528427)
Where are you located and sounds like driver mod is needed for sure :tapedshut:

Haha on driver mod I figure I'm going to get a lot of this
However I Also have a srt4 that I put in the mid 12s with
Slicks and e85 so yes it could be driver I guess
Anyway located in missouri

greenespeed 07-26-2012 11:08 AM

What was your e.t. with this mph.

EdgeAutosport.com 07-26-2012 11:09 AM

Quote:

Originally Posted by heli4me (Post 1528448)
Haha on driver mod I figure I'm going to get a lot of this
However I Also have a srt4 that I put in the mid 12s with
Slicks and e85 so yes it could be driver I guess
Anyway located in missouri

Yeah I was trapping 117 but with way more mods lol. More practice I say :)

heli4me 07-26-2012 11:19 AM

Quote:

Originally Posted by greenespeed (Post 1528454)
What was your e.t. with this mph.

Et was 14.40 with a 2.60 60 ft on stock dunslops
There were two other speed 3 there completely stock
They were 14.98/14.85 with 98/100mph
Track was not great but not bad temps were 60 or so

Tokay444 07-26-2012 11:22 AM

It's over 9000

superskaterxes 07-26-2012 11:24 AM

what RPM r u shifting at?

BigJimMs3 07-26-2012 11:28 AM

Quote:

Originally Posted by heli4me (Post 1528425)
Just looking to see what others are trapping in the 1/4. With similar
Mods as myselve...
I'm trying to figure out if I might have a issue with the car
Or driver....LOL
I have Sri - test pipe- water/meth injection- all 3 mounts
Tuned by a well respected tuner here on the forums with 50/50 e-85.
Anyway I have been reading it's nothing for our cars to
Trap 106/107 in the 1320 however mine can only hit 101
With the above mods ...
So just trying to get a comparison on this as to the possibility
That I might have a issue with my car ( other than the driver)
Thanks in advance ......

With the same mods and a dp subtract the meth my car did a 13.6 @ 107.6 2.460ft with the stock dunlops and it was about 80+ degrees and bat's were 120+ oh and was only on 3gal mix

zmarko 07-26-2012 11:28 AM

What elevation is it where you live/race?

heli4me 07-26-2012 11:41 AM

Quote:

Originally Posted by zmarko (Post 1528493)
What elevation is it where you live/race?

1268 ft

Quote:

Originally Posted by superskaterxes (Post 1528484)
what RPM r u shifting at?

Short shifting 1st then 6200
Tried different shift points also Just affected et slightly

Quote:

Originally Posted by BigJimMs3 (Post 1528490)
With the same mods and a dp subtract the meth my car did a 13.6 @ 107.6 2.460ft with the stock dunlops and it was about 80+ degrees and bat's were 120+ oh and was only on 3gal mix

That was about were I thought I should be also
I'm more concerned with mph
There are too many variables affecting et
But mph shows hp plain and simple
Thanks for the reply

greenespeed 07-26-2012 11:43 AM

The et and mph match up like they should. Although it does seem you should et and mph faster than this with your mods.

4G63 07-26-2012 11:43 AM

Where in Missouri are you located? That elevation seems high in the Missouri area

h.h.sk1nny 07-26-2012 11:48 AM

OP, shift that shit at 6k, and you'll improve everywhere. Above 6k is when the k04 is outta breath.

G26 07-26-2012 11:49 AM

104mph was my best, with a horrible bogged down launch and 2.7 60'.

Domino81 07-26-2012 11:50 AM

I trapped almost 103 the last time out running a 14.2 with the mods in my sig but a TMIC and no downpipe at the time and running 160 degrees BAT. Had I more of a chance to let it cool down or maybe go back on Sunday... I might be able to put something together like a mid-13 @ 106 or so like the car is capable of.

heli4me 07-26-2012 11:56 AM

Quote:

Originally Posted by greenespeed (Post 1528518)
The et and mph match up like they should. Although it does seem you should et and mph faster than this with your mods.

I also figured it should be quicker is why I'm starting to look
At the possibility I have something not right
While I was quicker than the other two speeds they both
Said they missed 3rd and did not run that night again

Quote:

Originally Posted by h.h.sk1nny (Post 1528529)
OP, shift that shit at 6k, and you'll improve everywhere. Above 6k is when the k04 is outta breath.

Thanks

atvfreek 07-26-2012 11:58 AM

With w/m I trapped 107.8

heli4me 07-26-2012 12:09 PM

Quote:

Originally Posted by atvfreek (Post 1528553)
With w/m I trapped 107.8

What size nozzle are you using m-7 ?

atvfreek 07-26-2012 12:15 PM

Quote:

Originally Posted by heli4me (Post 1528572)
What size nozzle are you using m-7 ?

d07 form devils own

heli4me 07-26-2012 12:21 PM

Quote:

Originally Posted by atvfreek (Post 1528581)
d07 form devils own

Same as I
Thanks


All times are GMT -7. The time now is 02:30 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
SEO by vBSEO ©2011, Crawlability, Inc.
vB.Sponsors

©Copyright 2008 ; 2019 Cymru Internet Services LLC | FYHN™ Autosports HQ
Ad Management plugin by RedTyger

Page generated in 0.18917 seconds with 11 queries